Netgear WiFi router is a great networking device to enjoy a blazing-fast internet speed in every corner of your home or workplace. However, similar to any other networking device, it is also susceptible to technical errors. One of the most common errors experienced by users is the Netgear router error 651 connection failed error pop-up.
In the event that you are also facing the same error, we have got your back! Here's an all-inclusive guide to show you some proven tactics to resolve the Netgear error 651. Read on.
Why Am I Getting Netgear Router Error 651?
Netgear router 651 error indicates that the internet connection you try to establish is failing. This error may also prevent you from accessing the Netgear router login web portal. There are various reasons why the network connection failure occurs. A few of them are listed below:
1. Corrupted network card driver
2. Improperly configured router
3. Registry files are corrupted
4. The configuration of internet protocol is not correct
5. No internet connectivity
6. The drive port file in saved in a wrong location
7. The IP address of your router and other connected devices is the same
Troubleshooting Tips to Fix Netgear Router Error Code 651
Important Note: The below-mentioned troubleshooting steps will be the same regardless of whether you have employed the netgear nighthawk ac1900 setup or another router model setup in your home.
1. Reconnect Your Netgear Router
It is the easiest way to fix the Netgear 651 error with your router. In order to reconnect your Netgear WiFi router, do the following:
1. Turn off your Netgear wireless router.
2. Disconnect all the connected devices (wired and wirelessly) to it.
3. Give your router some time to cool down.
4. Now, power up your Netgear router again.
5. Use an Ethernet cable and connect your router and modem using it.
6. Now, try connecting to a WiFi network.
2. Set up a Dial-up Connection Again
Possibilities are that the devices connected to your Netgear WiFi router hang. If this is the case with you, then recreate your dial-up connection. Here are the steps to recreate a dial-up connection:
1. Power on your computer.
2. Head over to the Change Adapter Settings section.
3. Thereafter, wait until a copy of your existing internet connection is created.
4. Now, remove the old connection and redial the new connection.
3. Reset TCP/IP on Your PC
Resetting the Windows networking stack is another way to get rid of the Netgear router error 651. Let's get to know how to do so:
1. Power up your PC.
2. Open the Command Prompt window.
3. Type the Reset command after the TCP/IP.
4. Once done, reboot your computer.
Now, try to access routerlogin.net web page. In the event that the page loads in a proper manner, it shows that the internet connection has been set up.
Kudos! Your Netgear router error code 651 is fixed now. Which troubleshooting step has solved the issue for you? Share your feedback with us via the comments below.
